淺談端子壓接區膜層對安全氣囊系統的影響

打開文本圖片集

【摘  要】本文簡單介紹安全氣囊系統的構成與原理，對故障車及零部件進行多種檢測，根據檢測結果對氣囊回路阻值高的問題進行深入分析，最終確定端子壓接區形成的膜層導致回路阻值異常，為從源頭上解決該問題提供依據。由于裝配不當造成的線路異常、零部件損壞等原因造成的故障不在本文討論范圍。

【關鍵詞】安全氣囊;高阻值;線束;端子壓接;膜層

中圖分類號：U463.62    文獻標志碼：A    文章編號：1003-8639（ 2022 ）07-0042-04

The Influence of the Film in the Terminal Crimping Area on the SRS

YUE Ben-long

（Beijing Automotive Technology Center，Beijing 100029，China）

【Abstract】Vehicles often report high resistance fault of SRS，which is eliminated after maintenance，but the fault reappears after a period of time，and the root cause cannot be found. This paper briefly describes the composition and principle of the SRS，carries out various tests on the faulty vehicle and parts，deeply analyzes the problem of high resistance of the SRS according to the test results，and finally determines that the film formed in the terminal crimping area leads to the high resistance of the circuit，which provides a basis for solving the problem from the source. The faults caused by improper assembly，such as abnormal circuit and damage of parts and components，are not discussed in this paper.

【Key words】SRS;high resistance;wire harness;terminal crimping;film

作者簡介 岳本龍（1981—），男，工程師，主要負責特種車輛系統集成工作。（剩余6155字）