四方鐵工作角偏差的測量不確定度分析

打開文本圖片集

【摘要】本文通過對四方鐵工作角的偏差測量結果的不確定度進行概算，根據JJF 1130—2005《幾何量測量設備校準中的不確定度評定指南》中目標不確定度合格判據U≤UT，確認本文提出的四方鐵工作角的偏差的技術要求、測量原理、測量條件、測量方法和測量程序的科學性、經濟性及可行性。

【關鍵詞】光學儀器檢具；四方鐵；不確定度

【DOI編碼】10.3969/j.issn.1674-4977.2023.02.016

Analysis of the Measurement Uncertainty of the Deviation of the Working Angle of Tetragonal Iron

LI Fan1，WANG Muhan2

（1.Liaoning Institute of Measurement，Shenyang 110004，China；2.Fushun Institute of Technology Innovation，F(xiàn)ushun 113006，China）

Abstract：This paper confirms the scientific，economical and feasible technical requirements，measurement principles，measurement conditions，measurement methods and measurement procedures of the square iron working angle deviation proposed in this paper by estimating the uncertainty of the measurement results of the square iron working angle deviation and according to the objective uncertainty qualification criterion U≤UT in JJF 1130—2005 Guidr to the Estimation of Uncertainty in Calibration of Geometrical Measuring Equipment.

Key words：optical instrument fixture；the quartet iron；uncertainty

1概述

標準角尺有200 mm×100 mm、100 mm×63 mm和70 mm×70 mm等規格。（剩余2457字）